Dürkopp Adler 550-867 Operating Instruction page 112

110
3. Tap the input field.
 The display switches to Stitches.
4. Enter the desired number of stitches.
5. Confirm with
To set the seam section switch via manual operation:
1. Open the Seam record set display ( p. 102).
2. Tap the Manual button.
 The checkmark confirms the selection.
Defining the length of the documented seam section
Here, you enter the length of the documented seam section in
mm. If is advisable to define the length of the documented seam
section for a seam record set.
While possible, defining the length of the free seam sections is of
less importance.
To set the length of the documented seam section:
1. Open the Seam record set display ( p. 102).
2. Tap the Total length input field.
 An input field appears.
3. Enter the desired length (mm).
4. Confirm with
Defining the threads
The permissible needle and hook threads must be defined for
each seam record set using IDs. The ID holds all important
information about the threads.
The machine checks at every start which needle thread and which
hook thread is currently being used. When a sewing process is
started, the machine will compare needle and hook thread with
those defined in the seam record set. The machine will detect if
the needle and hook threads fitted on the reel stand do not match
the seam record set. An error message appears. The sewing
process cannot be started.
.
.
Operating Instructions 550-867 - 00.0 - 11/2016
Programming