Dürkopp Adler 550-867 Operating Instruction page 116

114
Setting no start/end bartack
To specify that there will be no start/end bartack:
1. Open the Seam record set display ( p. 102).
2. Tap the no button below the heading Start/end tack.
The top two inputs under the heading Tack stitches are
reset to 0 for the start and the end bartack.
Setting a single start/end bartack
To set a single start/end bartack:
1. Open the Seam record set display ( p. 102).
2. Tap the single button under the heading Start/end tack.
3. Enter the desired number of stitches.
Setting a double start/end bartack
To set a double start/end bartack:
1. Open the Seam record set display ( p. 102).
2. Tap the double button under the heading Start/end tack.
3. Enter the desired number of stitches.
Setting the bartack stitch length
Here, you can set the stitch length of the start and end bartack.
Information
The shorter the stitch length of start and end bartack, the more
stable the bartack.
To set the desired bartack stitch length:
1. Open the Seam record set display ( p. 102).
2. Tap the input field Tack STL / mm/10.
 The display switches to Stitch length Tack [mm/10].
Operating Instructions 550-867 - 00.0 - 11/2016
Programming