Dürkopp Adler 550-867 Operating Instruction page 147

Programming
Operating Instructions 550-867 - 00.0 - 11/2016
Component
Store single
stitch data in
SAB seam
EFKA stitch in
stitch tacking ON
Thread tension
single stitch
checking
Calibration
control
Thread tension
graphics
Thread tension
regulator on
Edge measuring
Tack stitches for
each seam section
Light barrier
winder to check
if thread on
bobbin
Delete the bobbin
number from the
database by a user
with security level 0
(Delete bobbin
from DB by
operator)
Function
Saving the thread tension values of each
needle stitch in a documented seam section
to a TXT file
Selection according to EFKA parameter
setting (ornamental bartack or regular
bartack)
Definition as to whether the number of
stitches outside of the tolerance must be
distributed in sequence or along the entire
seam
Regular check of the step motor / the thread
force sensor
Visualization of the thread tension during the
sewing process
If the machine is used with an ETT, the
TARGET and the ACTUAL values of the
thread tension will be compared, and the
thread tension will be corrected (regulated)
automatically during sewing  p. 45
Additional equipment used to detect/monitor
the distance of the needle to the material
edge
Allows for setting different tack stitches for
start and end bartack in the respective seam
sections
This function is not active unless combined
with an attached forked light barrier
(optional). The forked light barrier checks if
the bobbin is empty before the bobbin can be
filled again. If there is remaining thread left on
the bobbin, the winding process will not start.
 p. 34
Here, you can define if a user with security
level 0 will also be allowed to delete a bobbin
number from the database  p. 80
If this function is activated, the button Delete
bobbin will also be displayed on the main
screen for users with security level 0.
145