Dürkopp Adler 550-867 Operating Instruction page 118

116
Defining the warning stitch count
A warning stitch count can be defined for the last seam section
into which the end label is supposed to be sewn. If the end label
barcode was not scanned and the end label was not sewn in before
the number of stitches warning is reached, the machine will stop
and display a warning ( p. 72).
This function is intended to ensure that the last free seam section
will not be completed without sewing in the end label. It is, there-
fore, advisable to define the warning stitch count in such a way
that there will be enough space for the end label to be sewn in
after the warning was displayed.
Switching foot lift for the documented seam section on and off
When the foot lift function is switched on for a documented seam
section, the sewing feet can be lifted at a sewing stop. If the foot
lift function is switched off, lifting the sewing feet manually in a
documented seam section will not be possible.
To switch the function Foot lift on/off:
1. Open the Seam record set display ( p. 102).
2. Switch the function Foot lift on/off or on off.
 If the checkmark is set, the sewing foot will be lifted at a
sewing stop.
 If the checkmark is not set, the sewing foot will not be lifted
at a sewing stop.
Adding a sewing section
A seam record set is composed of at least 1 and of no more than
20 seam sections.
The seam sections can be defined as any number of free or
documented seam sections.
Information
You can only add free seam sections. Not until it has been added
will you be able define if the new seam section is supposed to
remain free or become documented ( p. 104).
Operating Instructions 550-867 - 00.0 - 11/2016
Programming