Dürkopp Adler 550-867 Operating Instruction page 103

Programming
Operating Instructions 550-867 - 00.0 - 11/2016
Input field Function
Text printed on Define the text that will be printed on the end label.
end label This option is only available in documented seam
sections.  p. 180
Start tack Select if a single or double start bartack or no start
bartack will be created for the current seam section
 p. 113 et sqq.
Number of tack stitches (forward/backward)  p. 113
Tack stitches
End tack Select if a single or double end bartack or no end
bartack will be created for the current seam section
 p. 113 et sqq.
Stitch length of the start and end bartack  p. 114
Tack STL
Sew label on If activated, this function will activate the barcode
scanner of the end label in this seam section. The end
label barcode is supposed to be scanned, and the end
label is supposed to be sewn in at this seam section.
 p. 115
Thr. cutter The thread cutter cuts the thread at the end of the
current seam section  p. 115
on/off
Foot lift on/off Manual sewing foot lift at a sewing stop in the seam
possible/not possible  p. 116
The factory setting defines the same basic settings for all seam
sections. The settings can be changed individually for each seam
section.
The bars of the documented seam sections are set apart from the
non-documented seam sections by a different color ( p. 104).
The tallest bar in the row represents the present seam section in
which settings are currently being edited.
101