Dürkopp Adler 550-867 Operating Instruction page 117

Programming
Operating Instructions 550-867 - 00.0 - 11/2016
3. Enter the desired stitch length (mm/10).
4. Confirm with
Sewing in the end label
The end label is used to assign a unique production number to
the fully processed sewing material. This production number can
be scanned at any time using the end label barcode, revealing,
for instance, if an error occurred during the sewing process.
To switch on the function Sew label on:
1. Open the Seam record set display ( p. 102).
2. Select Sew label on.
 If the checkmark is set, the function Sew label on is
enabled.
 If the checkmark is not set, the function Sew label on is
disabled.
Switching the thread cutter on/off
If the thread cutter is switched on in a seam section, the thread is
cut at the end of the current seam section. The machine starts
sewing the next sewing section with a new seam.
The thread cutter (FA) can be switched on or off for every free
seam section. If the cutter is switched on, the machine begins
sewing the next seam section with a new seam.
To switch the FA on and off:
1. Open the Seam record set display ( p. 102).
2. Select the seam section for which the FC is supposed to be
switched on or off.
3. Select or deselect Thr. cutter on/off.
 If the checkmark is set, the FA is switched on.
 If checkmark is not set, the FA is switched off.
.
115