Dürkopp Adler 550-867 Operating Instruction page 106

104
Selecting a seam section
You can save different settings for each individual seam section.
The selected seam section will always be arranged slightly higher
than the other sections. In the example below, the first seam
section has been selected. The short black bar at the beginning
of the seam section indicates that this seam section begins with
a start bartack ( p. 113).
To select a seam section:
1. Open the Seam record set display ( p. 102).
Selecting a seam section
Fig. 93:
2. Tap the corresponding colored bar to select the seam section.
Defining a free seam section
To define a free seam section:
1. Open the Seam record set display ( p. 102).
2. Select the documented seam section you wish to convert into
a free seam section ( p. 104).
Fig. 94: Defining a free seam section
3. Tap the SAB button.
 The checkmark on the SAB button turns off, and the seam
section is no longer displayed as a documented seam section.
Operating Instructions 550-867 - 00.0 - 11/2016
Programming