Snack Products - Saeco Cristallo 600 EVO Use And Maintenance

During the brewing of a beverage:
• payment systems are disabled;
• the first line on the display shows the programmable
dispensing message (default message is: "WAIT FOR
PRODUCT").
Beverage selection
If the vending machine is not set to dispense free
beverages, insert the credit required.
Press the key corresponding to the beverage required.
When the beverage is dispensed, the message "REMOVE
CUP" is displayed. Take the beverage out of the dispensing
outlet.
After closing the door, "THANK YOU" is displayed. After
a few seconds "CRISTALLO" is displayed (vending machine
waiting for selection).
To avoid scalding, wait for
the end of brewing signal
(the message "REMOVE
CUP" will appear on the
display) before placing your
hand in the dispensing
outlet.
Do not
dispensing
while the vending machine
is brewing.
In case of failures or
product missing during the
brewing phase, a message
indicating the cause of this
stop will appear on the
display.
open the
outlet door
Special messages
signals are indicated in
chapter "Troubleshooting".
10.2

Snack Products

A special interconnection kit allows connecting up to 2
snack slave vending machines to the vending machine.
Snack Product Selection
If the vending machine is not programmed to dispense the
products free, it will be necessary to insert the required
credit and then select the 3-digit code in the desired spiral.
English
and
83