Saeco Cristallo 600 EVO Use And Maintenance page 104

English
Error
Cause
Code
Slow coffee boiler
warm-up
Slow instant product
boiler warming up
CRC error
Coffee grounds
moving device
blocked
Credit Manager
warning
Jammed capsule
release message
Jammed capsule
orientation device
message
Jammed capsule group
error message
Capsule group not
present error
message
Spiral motor error -
the machine has not
detected the spiral
position correctly.
Spiral motor excessive
input error
Power board power
supply voltage below
the allowed limit
Spiral motor not
detected at start-up
104
Machine without
snack slaves
Models with 2
36
boilers ==>coffee
beverages not
available
Models with 1
boiler ==>
Vending machine
out of service
37 Models with 2 boilers
==>beverages with
instant products not
available
Instant Models ==>
Vending machine out of
service
38 ---
error not reported
39
(device not
available)
42 Warning only
43 Beverages with
capsules not
available
44 Message only (note:
the dispensing of
capsules will
continue until there
are no more
capsules in stock)
45 Beverages with
capsules not
available
Beverages with
46
capsules not
available
51 ---
52 ---
54 ---
55 ---
Machine With
Notes / Recommended Intervention
Snack Slaves
Models with 2 Check the coffee boiler (connections,
boilers ==>coffee thermostats)
beverages not
available
Models with 1
boiler ==> no
beverage available
Beverages with ---
instant products
not available
---
error not reported
Warning report only in the LOG.
(device not
available)
The credit management system has
Warning only
overcome a possible blocking condition
(credit watch-dog enabling)
Check the capsule release mechanism.
Empty the orientation device and remove
anything preventing its rotation (e.g.
jammed capsule).
Check the capsule brewing group
gearmotor and/or the
microswitches.positioning.
Check the capsule brewing group
gearmotor and/or the
microswitches.positioning.
Selection disabled Selection disabled.
Use the "automatic alignment" to enable
again.
Selection disabled Selection disabled.
Use the "automatic alignment" to enable again.
Warning only Check the +24VDC power supply unit.
Slave disabled Check the spiral tray connections