Saeco Cristallo 600 EVO Use And Maintenance page 97

Remove the used perforator and put the new perforator
back in place.
The perforator can be
installed only in a pre-set
position. To install the
perforator correctly, use
the notch placed inside the
piston stop as a reference.
The perforator must be
replaced
damaged.
if a pin
11.3.2.2 Removing the lower piercer
To remove the piston, pry on the rod using a flat-head
screwdriver as shown in the figure.
is
Remove the other end of the rob from the piston slot.
English
97