Saeco Cristallo 600 EVO Use And Maintenance page 77

9.3.3 Description of messages in the maintenance menu
DISPLAY
1.
MAINTENANCE
...
1.1.
Error log
...
1.2.
Rinsing time
...
1.3.
Water Filter
...
1.3.1.
Last filter change
...
1.3.2.
Remaining qty
...
1.3.3.
Filter reset
...
1.4.
Calibrations
...
1.4.1.
Dose C calib.
...
1.4.2.
Brew Group Calib.
...
1.4.3.
EV calib.
...
1.4.4.
Capsule calibration
1.4.5.
C coffee calibration
This function allows to show and reset the errors that may be present.
It is also possible to carry out maintenance on the vending machine.
To reset the errors, use the menu under the maintenance item.
Important
To correct errors see chapter "Troubleshooting" and section "5-button Keypad".
The VM stores in its internal storage significant incidents occurring in the VMC (for example errors, trouble
signals etc. )
Recording takes place when the error condition is detected and consists of saving the following information:
1- error code (or warning code) occurred
2- location of signal source (e. g . , which spiral motor, if the error is due to a spiral motor, or which coffee or
instant product)
3- day, month, hour and minute of error detection (this information is available only if the VM is equipped with
a timekeeper).
Display:
Format of warning error description recorded in LOG:
See "LOG TABLE"
It allows to rinse the brewing circuits of instant products.
By pressing the ENTER key the automatic cycle starts, thus activating in sequence each
instant product circuit.
Allows the use of the water filter to be checked.
Date of the last filter reset.
Number of litres of water that can still be dispensed before the filter needs to be
regenerated.
When this value is less than 1, a Warning (W83) is recorded in the Error LOG.
Select YES to indicate a new filter has been installed
This operation returns "Remaining Qty" to the same value as "Filter Limit" and the date in
the "Last Filter Change" is changed to today's date.
Allows some calibration operations to set up the machine.
Allows checking the quantity of powder dispensed by dosing unit 2.
To carry out the check, you must:
1. remove the brew group
2. prepare a container (e.g. a cup) to collect the coffee powder
3- Select "Yes" from the menu, the machine grinds a coffee dose and discharges it
4- check if the weight of the resulting dose corresponds to what expected, otherwise adjust
the dosing unit as shown in section "Dose Adjustment".
Allows handling the coffee brew group.
Allows selecting one of the solenoid valves on the vending machine and activating it for 10
seconds, in order to check the flow (flow adjustment is described in par. "Water Flow
Adjustment of Instant Product Solenoid Valves").
Allows a water dispensing of 100 turbine pulses through the capsule group (use with
template group)
Allows a water dispensing of 100 turbine pulses through the espresso beans group (use with
template group)
Description
English
77