Software Update - Saeco Cristallo 600 EVO Use And Maintenance

English
• Turn the conveyor channel and remove the jammed
capsule.
• Replace the conveyor channel in its original position and
re-insert the front orange knob.
11.4

Software update

The vending machine management program is stored in
the flash memory inside the CPU board.
The software update can be performed by using:
• a USB key (Pen Drive);
• a file containing the new software to be loaded.
Update procedure:
• copy the "SAE_NCRI_V00000.s19" file received for
update (where XXXXX is the version number) onto a
USB key* (the file should be stored on the device root);
• rename the file as: "SAE_NCRI.s19 ".
If the file name is not
correct, the software will
not be recognised (the red
light on the CPU will
remain on).
100
If the file name contains
empty spaces, the software
will not be recognised (the
red light on the CPU will
remain on).
• switch off the vending machine;
• insert the USB key into the CN1 connector;
• press and hold the P1 button on the CPU;
• Switch on the vending machine;
• after the CPU beep, release the P1 button;
• The CPU recognises the USB key and searches for the file with
the software to be loaded (green and red lights on the CPU flash
alternatively);
• In case of errors, a long beep is emitted and the red light stays
on.
• 3 close beeps and the restart of the vending machine confirm
that the software has been updated.
• switch off the vending machine;