Saeco Cristallo 600 EVO Use And Maintenance page 53

DISPLAY
1.12.
Stirrer
1.13.
Cup Management
1.13.1.
Cup Dispenser
1.13.1.1.
Enable
1.13.1.2.
Cup stock
1.13.1.3.
Cup Col. Stop Delay
1.13.1.4.
Tube posit.
micro
1.13.2.
Disp. outlet micro
1.13.3.
Cup Sensor
1.13.3.1.
Enable
Enables selection of the stirrer dispensing mode.
STIRRER ALWAYS: the stirrer is dispensed anyway;
STIRRER SUGAR: the stirrer is dispensed only if the beverage is served with sugar;
STIRRER SUGAR OR BITTER: the stirrer is dispensed for all the beverages which should be served with sugar,
although the user requires them without it.
STIRRER NEVER: the stirrer is never dispensed.
Cup dispenser settings.
It enables using the cup dispenser.
It sets the number of cups left in the dispenser when the refill microswitch for the following
cup column has to be activated.
Delay between the time when the cup column falls into the vending machine slot and when
the column motor stops.
Set to YES if the paper cup dispenser is equipped with cup holder positioning microswitch
Allows cup detection inside the dispensing outlet.
When checking is enabled, dispensing new products is not allowed until the paper cup of
the previous beverage is still inside the outlet.
Removal is detected by the photoelectric cell (if any) or by opening the dispensing outlet.
Important
If you wish to use the VM with the dispensing door always open, it is necessary to
short-circuit the wiring of the dispensing outlet microswitch.
(Optional kit)
Enables management of the cup sensor.
It enables the cup sensor.
Description
English
53