Saeco Cristallo 600 EVO Use And Maintenance page 62

English
DISPLAY
3.3.
H2O / Coffee
1
38
3.3.
Freshbrew Water
3.3.
Pre-ground Water
3.3.
Fresh inst. time
3.3.
Pre-gr.inst.time
3.3.
Just water 1
101
3.3.
% instant product #:
1
3:50
3.3.
% pump #: 1
3:50
3.3.
Instant prod. 1
dose #:
3:005
3.3.
Inst. prod.
1
water #:
3:022
3.3.
Include cup 1
yes
3.3.
Sugar 1
2
62
This defines the quantity of coffee to be brewed.
The quantity of dispensable coffee can be adjusted from "1" to "999".
Sets the quantity of water to be dispensed for the programmed coffee type (C, P, F, or B).
The quantity can be set from 1 to 999.
Sets the quantity of water to be dispensed for the programmed coffee type (C, P, F, or B).
The quantity can be set from 1 to 999.
Instant freshbrew dose
Instant pre-ground dose
Defines the amount of hot water to be dispensed.
It determines the instant powder delivery rate.
The value can be set between 10 and 100.
The lower the value the smaller the powder delivery rate.
It determines the water delivery rate.
The value can be set between 20 and 100.
The lower the value the smaller the water delivery rate.
This defines the quantity of instant product to be brewed.
Example: "005" quantity indicates that the motor of the instant product 3 will be activated for 5 tenths of a second.
The quantity of instant product is adjustable from "1" to "100" in steps of 1.
Brewing of the instant product does not occur when the parameter is set at "0000" (in this case water is brewed).
It defines the amount of water to be mixed with the instant powder.
Example: "3" indicates that water will be mixed with the instant product 3.
"022" indicates that 22 units of water will be brewed with the instant product.
The reference unit is preset by the manufacturer.
The amount of water can be adjusted from '"1" to "999" in steps of 1.
Important -1
If the instant product parameters ("INSTANT PRODUCT - WATER - % INSTANT PRODUCT" -
% PUMP) are set so as to make the powder dispensing procedure last longer than the water
dispensing one, the vending machine will stop the powder dispensing. This is meant to avoid
insufficient mixer washing.
Readjust the set parameters in order to have a correct dispensing procedure, i.e. the powder
dispensing should stop a few seconds before the water stops flowing out. This is intended to allow
correct mixer washing.
Important -2
If the sequence includes more instant products, the sequence "INSTANT PRODUCT - WATER - %
INSTANT PRODUCT" - % PUMP" will appear for each instant product.
Allows choosing whether the beverage will be dispensed using the cold beverage dispensing kit
Allows choosing whether the beverage will be dispensed with or without paper cup.
This defines the quantity of sugar to be dispensed with the beverage.
The following "SUGAR TABLE" indicates the effects due to the different settings.
Description