Table 51: Port Settings - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide
Related
Documentation
114
To configure the modem on the services gateway end:
Connect the modem to the management device (a desktop or laptop computer).
1.
Power on the modem.
2.
From the management device, start your asynchronous terminal emulation application
3.
(such as Microsoft Windows HyperTerminal), and select the
modem is connected (for example,
Configure the port settings, as listed in
4.

Table 51: Port Settings

Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
In the HyperTerminal window, type AT.
5.
For more information on the AT commands, see the
for Security Devices .
An response verifies that the modem can communicate successfully with the
OK
port on the management device.
To configure the modem to answer a call on the first ring, type ATS0=1.
6.
To configure the modem to accept modem control DTR signals, type AT&D1.
7.
To disable flow control, type AT&K0.
8.
To save modem settings, type AT&W.
9.
Connecting to the SRX550 High Memory Services Gateway from the CLI Remotely on
page 133
Connecting the Modem to the Console Port on the SRX550 High Memory Services
Gateway on page 110
Connecting the CLI at the User End for the SRX550 High Memory Services Gateway
on page 112
COM
).
COM1
Table 51 on page 114.
Value
9600
8
None
1
None
Installation and Upgrade Guide
Copyright © 2016, Juniper Networks, Inc.
port to which the
COM