Connector Pinouts For The Srx550 High Memory Services Gateway Ethernet Port - Juniper SRX550 Hardware Manual

Table 21: Cable and Wire Specifications for Ports and Alarm Interfaces
Port Cable Specification
Console RS-232 (EIA-232) serial
cable
USB console USB
Ethernet Category 5 cable or
equivalent suitable for
100Base-T operation
NOTE: The Auxiliary port is not supported on the SRX550 Services Gateway.
RJ-45 Connector Pinouts for the SRX550 High Memory Services Gateway
Ethernet Port
The port on the front panel labeled ETHERNET is an autosensing 10/100-Mbps Ethernet RJ-45 receptacle
that accepts an Ethernet cable for connecting the services gateway to a management LAN (or other device
that supports out-of-band management).
the Ethernet port.
Table 22: RJ-45 Connector Pinouts for Services Gateway Ethernet Port
Pin
1
2
3
4
5
Cable/Wire Supplied
One 6-ft (1.83-m) length with
DB-9/DB-9 connectors
One 6-ft (1.83-m) length with
Mini-B and Type A plugs
One 15-ft (4.57-m) length with
RJ-45/RJ-45 connectors
Table 22 on page 69 describes the RJ-45 connector pinouts for
Signal
TX+
TX-
RX+
Termination network
Termination network
Maximum Device
Length Receptacle
6 ft (1.83 m) RJ-45
6 ft (1.83 m) Mini-B USB
Socket
328 ft (100 m) RJ-45
autosensing
69