Table 7: Srx550 High Memory Services Gateway Front Panel Leds - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide

Table 7: SRX550 High Memory Services Gateway Front Panel LEDs

LED Label LED State
ALARM On Steadily
Off
STATUS On Steadily
Off
POWER Steadily on
Off
HA Steadily on
Off
MPIM-1, On Steadily
MPIM-2
Off
18
LED Color Description
Amber Indicates a major alarm, such as low Services Processing Unit (SPU) memory
(less than 10% remaining), session full, maximum number of VPN tunnels reached,
high availability (HA) status changed, or redundant group member not found.
Red Indicates a critical alarm, such as a failure of a hardware component or software
module.
Unlit Indicates that the device is starting up.
NOTE: When the system is up and running, if the ALARM LED is off, it indicates
that no alarms are active on the device.
Green The services gateway is functioning normally.
Amber The services gateway is starting up, running diagnostics, or shutting down.
Red The services gateway has failed.
Unlit The services gateway is powered off.
Green The services gateway is functioning normally and that the services gateway and
all power supply units (PSUs) are receiving power.
Red At least one PSU has failed.
Amber The Power button has been pressed and the services gateway is shutting down.
Unlit The services gateway is not receiving power.
Green All configured high availability links are available.
Red High availability links are not working as expected and a cluster member might
be missing or unreachable.
Amber Some configured high availability links are down, but enough links are still active
for full high availability functionality. In this situation, performance might be
reduced, current bandwidth could cause packet drops, or a single point of failure
might now exist.
Unlit High availability is not enabled.
Green The Mini-PIM in the corresponding slot is functioning normally.
Red The Mini-PIM hardware in the corresponding slot has failed or its anti-counterfeit
check failed.
Unlit There is no Mini-PIM in the corresponding slot, or that the Mini-PIM is not detected
by the device.
Copyright © 2016, Juniper Networks, Inc.