Figure 24: Connecting To The Usb Console Port On The Srx550 High Memory - Juniper SRX550 Hardware Manual

Copyright © 2016, Juniper Networks, Inc.
Chapter 16: Connecting the SRX550 High Memory Services Gateway to External Devices
Figure 24: Connecting to the USB Console Port on the SRX550 High
Memory Services Gateway
To connect to the CLI using a local management device through the USB console port
on the services gateway:
If you have not already done so, obtain the USB console driver software from the
1.
Juniper Networks website
Install the USB console driver software by following these steps:
2.
CAUTION: Install the USB console driver software before attempting to
establish a physical connection between the services gateway and the
management device, otherwise the connection will fail.
Copy and unzip the USBDriver.zip file to your local folder.
a.
Double-click the .exe file. The Juniper Networks CP210X USB to UART Bridge Driver
b.
installer window appears.
Click .
Install
c.
Click
d. Continue Anyway
NOTE: If you choose
then all or part of the software will fail to install. In such a case, it is
recommended that you uninstall the USB console driver and then
reinstall it.
Click when the installation is complete.
e. OK
Plug the large end of the USB cable supplied with the services gateway into a USB
3.
port on the management device (see
http://www.juniper.net/support/downloads/group/?f=junos
on the next screen to complete the installation.
STOP Installation
Figure 24 on page
at any time during the process
111).
.
111