Lan Interface Modules - Siemens HiPath 1100 Service Manual

7.2.1.3

LAN interface modules

This option uses LAN access via the ADSL, SLIMC, SADSLIM, LIMC or ADSLIM modules.
Install the HiPath 1100 applications from the CD, restart the PC, then make the necessary
settings on the HiPath 1100 Manager for connection with the CommServer.
Procedure:
1. Insert the HiPath 1100 CD in the CD drive
If Auto-Run is not configured, go to the Windows Start menu, click Run and then select the
Browse button in the dialog box. Open the SETUP.EXE file on the CD drive.
2. In the Setup window, select the language you want to use
3. A window will appear where you can select the software to be installed
4. Install your selected software components sequentially. For programming the HiPath 1100
system, the following applications must be installed:
HiPath 1100 Manager and
●
CommServer (installs automatically).
●
5. After each component is installed, a message is displayed indicating that the installation
was completed successfully. Click "Next" every time it appears
6. Click "Finish" to close the installation window. This completes the software installation.
Windows may display a message to restart the computer. If this occurs, restart the
computer.
7. ADSL module - After installation is completed, configure the CommServer (see Figure 7-
4). Right-click the CommServer icon on the Windows status bar and select Properties.
1. Select ADSL connection
2. Configure the IP of the ADSL module:
If the "Get IP # Automatically" checkbox" is enabled, the CommServer will
automatically be configured with the IP of the default gateway of the PC, if not, the IP
of the ADSL module must be entered manually into the CommServer (Default
10.0.0.1).
Service Manual
System programming mode using a PC
Operation
7-285