Siemens HiPath 1100 Service Manual page 257

Date for updating the call cost limit for an extension (045)
This specifies a day for resetting the Call Charge limit.
Setting a system password (180)
Access to the system's programming mode is protected by password to prevent unauthorized access. The default password
is "31994." This password can be changed.
Make a note of the new password and store it in a safe place. If you forget the pass-
word, the only way to access programming mode is by asking a support technician
to give you access.
Night service password (149)
Independently of the system password, an additional password can be defined for activating/deactivating different features
(e.g., Night service, relays). The default password is "31994." This password can be changed.
Restoring default settings (199)
Restores all default factory settings. After entering this code, the system will restart. Only the settings for Country/Group of
Countries (Code 65) will be saved as last configured.
Regular timers and System timers (139 and 140)
These settings allow you to reset the times for some features and signals according to the specific characteristics of a user or
a country.
DTMF signals for the sensor (177)
When an alarm is activated, the HiPath 1120 dials the number on entry 249 of the Phonebook. The numbers are dialed and the
sequence of digits, in DTMF format, is repeated every 5 seconds after the connection is established. The purpose of this se-
quence of digits is to identify the alarm source. An alarm center, for example, is able to identify which PABX is sending the
tone. If the receiving exchange does not acknowledge the alarm within 1.5 minutes, the procedure is repeated every 3 minutes.
Emergency numbers (040)
You can specify up to five emergency numbers. When one of these numbers is dialed and all external lines are busy, the call
on the first external line will be interrupted and the line used for making the emergency call. Only an incoming call over an
analog external line will not be disconnected.
.
The name assigned to these numbers can have up to 15 characters.
Emergency Numbers are not affected by the ACS feature.
Emergency calls never use external lines configured for:
Internet access
●
Absent external line
●
An external line configured to accept only incoming calls
●
Service Manual
Configuring the system specifically for the client
Comments about the system's programming codes
6-257