Siemens HiPath 1100 Service Manual page 261

External number configuration (067)
This specifies external numbers (Service MSN without external access code 0) that are able to perform remote administration.
The default configuration does not specify an MSN.
Remote Administration Password (068)
This specifies a password (5 digits) for enabling Remote Administration from an external number (Service MSN).
The default configuration does not specify a password.
Remote MSN (069)
This setting specifies an ISDN line MSN as the Remote MSN.
The system will only allow Remote Administration when this remote MSN is used.
The default configuration does not specify an MSN.
Without MSN Verification (070)
Remote Administration will be performed without verifying the Service MSN that has been transmitted.
Remote Administration via DTMF (157)
With this feature you can configure the HiPath 1100 remotely using an MF telephone.
Remote configuration:
●
Remote Configuration must be enabled and the programming extension must have a
conversation in progress on the external line over which programming is to be performed.
In Talk mode, enter the code (*991) in the programming extension to transfer control of the
HiPath 1100 to the remote programmer. The remote programmer must then enter the
system password using an MF telephone.
To execute the required programming, proceed as if the remote telephone were connected
directly to the system.
If a Fax/DID module is available:
●
Enter the code (* 95) using the remote MF telephone after answering the call. The remote
programmer must then enter the system password using an MF telephone.
To execute the required programming, proceed as if the remote telephone were connected
directly to the system.
If the system is connected through a serial cable to a PC with access to the tele-
phone system, the programming can also be done using a modem in conjunction
with the HiPath 1100 Manager. Refer to the instructions provided in the Help file.
Ending Remote Administration (196)
Ends remote configuration using a standard MF telephone.
Service Manual
Configuring the system specifically for the client
Comments about the system's programming codes
6-261