Caution
!
Always use an anti-static wrist band when working with the HiPath 1100 systems
(particularly when handling the modules). Make sure the wrist band is grounded.
4.3
Select the location for installing the equipment
Installation Location
The system's installation site has been previously selected and agreed to by the client.
The following precautions must be taken:
Do not expose the equipment to any external heat source (e.g., sunlight, heaters, etc.)
●
Do not expose the equipment to excess dust
●
Do not install the equipment in areas where there is a risk of condensation when the
●
equipment is in use. If condensation occurs, dry the equipment before starting operation.
Do not install inside closets.
●
The power outlet for connecting the system's power supply must be located close to the
●
equipment and must be easily accessible.
Follow all environmental guidelines described in the chapter "System Data" (see
●
"Environmental conditions" on page 2-40).
Do not install in vibrating walls.
●
Warning
!
When using the RSA version, extension lines with a C/D interface must only be in-
stalled indoors. Only regular extensions (without a C/D interface) can be installed
outdoors.
Note 1: See Section "Configurations HiPath 1100" on page 2-27 for more information
regarding system configurations.
Service Manual
Select the location for installing the equipment
Installation
4-127