Notes On Hipath 1150 - Siemens HiPath 1100 Service Manual

HiPath 1150/1190
The table below shows the settings available for KS with optiPoint using U
None
U (2 Ports)
P0/E
U (4 Ports)
P0/E
U (8 Ports)
P0/E
Table 2-7 optiPoint and KS telephones for HiPath1150/1190/1190R.
Limitations:
If an 8-port U module is installed, the system will not free up another U
P0/E
system. Both the HiPath 1150 and the HiPath 1190 allow a maximum of 8 U
in 16 optiPoint telephones (master + slave) + 8 KS telephones, for a total limit of 24 system
telephones. Therefore, only combinations of UP0/E modules are possible for a maximum of 8
ports.
2.5.3

Notes on HiPath 1150

If there are only 2 PCM highways in the HiPath 1150 and one module TME1 is used, we would
have 30 timeslots reserved and a further 2 timeslots reserved for the analog trunks, which
would mean fewer than 32 timeslots free for all the other extensions of the system. To avoid this
limitation, the solution was to use an additional highway based on the DSP control for slots 3
and 4.
SLOT 2
SLOT 1
Figure 2-5 Distribution of the highways in the HiPath 1150
Service Manual
None U (2 Ports)
P0/E
0/0/8 2/2/8
2/2/8 4/4/8
4/4/8 6/6/8
8/8/8 8/8/8
Master/Slave/KS
U (4 Ports)
P0/E
4/4/8
6/6/8
8/8/8
8/8/8
SLOT 4
SLOT 3
System Data
System expansion limitations
P0/E
MODULES
U (8 Ports)
P0/E
8/8/8
2/2/8
4/4/8
8/8/8
module in the
P0/E
ports, resulting
P0/E
Highway A
Highway B
Highway C
:
2-35