4.8
Installing the power supply
Introduction
Before connecting the power supply to the system, see "Technical Data" on page 2-
38 " and "Power Supply Unit (PSU)" on page 3-93.
4.8.1
On the HiPath 1120
Installation Procedures
Step
1.
Check network voltage
2.
If the voltage is within the power supply's voltage range, connect the power supply.
3.
"Performing a visual inspection" on page 4-189
4.
Configure the required data (see "Operation" on page 7-278).
Warning
!
Use the cable of the power supply to turn system power on or off.
Figure 4-32
Installing a power supply on the HiPath 1120
Service Manual
Procedure
Installation
Installing the power supply
4-163