1.1.3
Safety Information: Caution
Checking and Measuring Voltage
Check rated voltage for recommended system installation.
●
Proceed very carefully when making measurements on live components or when servicing
●
equipment with the power on.
Main Circuit Breaker
Know the location of the system's main circuit breaker and its conductive capacity. Check this
information against the exchange specifications in "Technical Data" on page 2-38 to assess
compatibility.
Damage
Only use tools and equipment that are in perfect condition. Do not operate equipment that is
damaged. Report any problems to your supervisor.
ESD Protection for Components (ESD)
To protect an electrostatically sensitive device:
Wear an anti-static wristband before servicing or maintaining the system or any of its
●
modules.
Always transport the system or its modules in appropriate protective packaging.
●
When working with boards, always place them on a grounded conductive base.
●
Use grounded soldering irons with only.
●
Layout of the Cables
Position cables in a manner to prevent damaging them or causing accidents and injuring
people.
Batteries
Batteries that are not correctly installed or batteries replaced with a different type than the one
specified can be an explosion hazard. Replace battery with an identical type of battery or use
a type recommended by Technical Support. Dispose of used batteries according to your
countries laws and regulations.
Service Manual
Important Information
Safety Information
1-21