Installation
Installing modules
4.7.9
Installing a CTR-
4.7.9.1
On the HiPath 1120
Installation Procedures
Step
1.
Turn off the power supply.
2.
Remove the system's cover
3.
Attach the module to the corresponding Connector on the MB
4.
Reassemble the entire set.
5.
"Performing a visual inspection" on page 4-189.
6.
Turn on the power supply.
7.
Configure the required data (see "Operation" on page 7-278).
Assembly Diagram
Figure 4-28
Installing a CTR- U
4-158
module
U
P0/E
Procedure
HiPath 1120 module
P0/E
Service Manual