DSC HS2128 Reference Manual page 135

2. Press [*] to select the module type then scroll to the specific module you want to confirm. Press [*] to enter Confirmation
mode. The module's serial number and slot number are displayed on the keypad and the status LEDs on the device flash.
This continues until confirmation mode for the device is exited via the [#] key.
Note: Keypad Blanking (section [016], option 3) must be disabled to confirm keypads.
Note: When using an LED or ICON keypad, use the following table to match the number displayed on the keypad to a mod-
ule.
Table 6-4 Module numbers when programming with an LED or ICON keypad
# displayed on keypad
18
19
24
28
30
50
51
52
53
56
57
59
5A
5B
5C
60
67
6B
6D
95
96
6.3.21 Testing
[904] Wireless Placement Test
This test is used to determine RF signal status for wireless devices and can be performed at a system keypad or at the indi-
vidual device. These instructions pertain to testing at the keypad. For instructions on placement testing at the device, refer to
the installation sheet included with the wireless equipment.
The following test modes are available:
Section 6: Programming
Model # Description
HSM2108 Neo 8 zone expander module
HSM2HOST Neo PowerG wireless tranceiver module
HSM2204 Neo 4 high current output module
HSM2208 Neo 8 output expander module
HSM2300 Neo 1A power supply module
HS2LCD Neo 2x16 LCD keypad
HS2ICN Neo Icon Keypad
HS2LCDP Neo 2x16 LCD keypad with Prox
HS2ICNP Neo Icon Keypad with Prox
HS2LED Neo 16 LED keypad
HS2TCHP Neo Touchscreen Keypad with Prox
HS2LCDRF Neo 2x16 LCD RFK keypad
HS2ICNRF Neo Icon RFK Keypad
HS2LCDRFP Neo 2x16 LCD RFK keypad with Prox
HS2ICNRFP Neo Icon RFK Keypad with Prox
HS2LCDWF Neo 2x16 LCD wirefree keypad
HS2TCHWF Neo Touchscreen wirefree Keypad
HS2LCDWFP Neo 2x16 LCD wirefree keypad with Prox
HS2LCDWFPV Neo 2x16 LCD wirefree keypad with Prox and Voice
HSM2955 Neo Audio alarm verification module
HSM2955R Neo Audio alarm verification module with Recording
- 135 -