DSC HS2128 Reference Manual page 133

[001]-[016] keypads
[101]-[115] 8-zone expansion module
[201] 8-output expansion module
[460] Alternate Communicator
[461] HSM2Host module
[501]-[504] 1A power supply module
[521]-[524] high-current output modules 1-4
[901] Installer Walk Test Mode Enable/Disable
This mode tests the operation of each detector in the system. Enter section [901] to initiate a walk test. While in Walk Test
mode, the Ready, Armed, and Trouble LED's on the keypad flash to indicate that the test is active. When a zone is tripped
during the test, a 2-second tone sounds on all system keypads to indicate that the zone is working correctly.
After 10 minutes without zone activity, the alarm system emits 5 beeps every 10 seconds from all keypads. After another 5
minutes of inactivity, Walk Test terminates automatically.
To manually exit walk test mode, enter [901] again.
6.3.20 Module Programming
Use this section to add, remove and confirm the following modules:
Keypads see "Compatible Devices" on page 9
l
8-zone expander module (HSM2108)
l
8-output expander module (HSM2208)
l
Power supply (HSM2300)
l
4-output power supply (HSM2204)
l
Wireless transceiver (HSM2HOSTx)
l
Audio Verification Module (HSM2955)
l
Once added, modules are supervised by the system.
[902] Add/Remove Modules
Modules can be enrolled automatically our manually. In either case, the serial number of the device is used as an identifier.
Select one of the enrollment options described below.
[000] – Auto Enroll Modules
When this mode is selected, the alarm system automatically enrolls all modules connected to the Corbus. The total number
of modules currently enrolled are displayed on the keypad.
Enter sub-section [000] to begin auto enrollment of all new modules. The auto enroll screen will show the following:
l
KP = Number of keypad type modules
l
IO = Number of zone and output type modules
l
M = Number of other type modules
l
Devices are assigned to the next available slot. The slot assignment can be modified using subsections [002] and
[003].
[001] – Enroll Modules
To enroll modules individually:
1. Enter programming section [902][001].
Section 6: Programming
- 133 -