Table of Contents
Advertisement
[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (x page 59) for the operation of the menu screen.
[STATUS]
Display the status of the projector.
1)
Press as to select [STATUS].
2)
Press the <ENTER> button.
f The [STATUS] screen is displayed.
3)
Press as to switch the pages.
f The page will change each time you press the button.
[SIGNAL]
[RUNTIME]
[SERIAL NUMBER]
[VERSION]
Note
f For the network status, refer to the [NETWORK] menu → [NETWORK STATUS]. (x page 98)
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1)
Press as to select [PROJECTOR ID].
2)
Press qw to select a projector ID.
f To select one item among [ALL] and [1] ~ [64].
[ALL]
[1] ~ [64]
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
If multiple projectors are set up side by side with ID set to [ALL], you cannot control a projector separately by specifying a different ID
number.
f Refer to "Setting the ID number on the remote control" (x page 56) for how to set the ID number on the remote control.
[INITIAL START UP]
Set the startup method when the projector is switched on after connecting the power plug to outlet .
1)
Press as to select [INITIAL START UP].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY]
[STANDBY]
[ON]
Chapter 4 Settings - [PROJECTOR SETUP] menu
[NAME]
Displays the name of input signal.
[FREQUENCY]
Displays the scanning frequency of input signal.
[PROJECTOR]
Displays the actual usage time of projector.
[LIGHT RUNTIME]
Displays the runtime of the light source.
Displays the elapsed time from when the light source is illuminated.
[CONTINUOUS
The elapsed time is reset when the light source is temporarily turned off such as using
LIGHTING TIME]
the shutter function.
[PROJECTOR]
Displays the serial number of the projector.
[MAIN]
Displays the main version of the firmware of the projector.
[SUB]
Displays the sub version of the firmware of the projector.
[LD]
Displays the version of the light driver of the projector.
Select when controlling projectors without specifying an ID number.
Select when specifying an ID number to control individual projector.
Starts up in the status that before removing the power plug from the outlet or turning off the circuit
breaker.
Starts up in the standby mode.
Starts the projection immediately.
ENGLISH - 83
Advertisement
Chapters
Table of Contents
