Switching On The Projector; When The Initial Setting Screen Is Displayed - Panasonic PT-CMZ50 Operating Instructions Manual

Switching on the projector

Before switching on the projector, make sure all the other devices are correctly connected (x page 38).
1) Connect the power cord to the projector.
2) Connect the power plug to an outlet.
f The power indicator <ON(G)/STANDBY(R)> lights/blinks, and the projector will enter the standby mode.
3) Press the power <v/b> button.
f The power indicator <ON(G)/STANDBY(R)> lights green and the image is soon projected on the screen.
Note
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it takes longer for the projection to
start after the power is turned on, compared to when set to [NORMAL].
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] is set to [ON], and the power is turned on before
the specified time elapses after the projector enters the standby mode, an image will be projected approximately one second after the power
is turned on.
The specified time is a time set in the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] → [VALID PERIOD].

When the initial setting screen is displayed

When the projector is switched on for the first time after purchase, the focus adjustment screen is displayed
after the projection starts, followed by the [INITIAL SETTING] screen and the [ADMINISTRATOR ACCOUNT]
screen. When the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is executed, the focus adjustment screen is
displayed after the projection starts, followed by the [INITIAL SETTING] screen. When the [NETWORK] menu →
[INITIALIZE] is executed, the [ADMINISTRATOR ACCOUNT] screen is displayed after the projection starts next
time. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
When the [INITIAL SETTING] screen is displayed, you can return to the previous screen by pressing the
<MENU> button or <RETURN> button.
Focus adjustment
Adjust the focus to display the menu screen clearly.
1) Press asqw to adjust the focus at the center of projected image.
f Pressing the <FUNCTION> button can hide or display the focus test pattern.
2) Press the <ENTER> button.
3) Press asqw to adjust the focus in the periphery of the screen.
4) If necessary, press the <ENTER> button and repeat Step 1) to adjust the focus at the center of
projected image again.
46 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector
1)
2)
FOCUS
Plesae adjust periphery focus after
RETURN
PERIPHERY FOCUS
ADJUST
PATTERN OFF
3)
CENTER FOCUS
center focus adjustment.
3)