Projector Body - Panasonic PT-VMZ40 Operating Instructions Manual

Attention
f Do not drop the remote control.
f Avoid contact with liquids.
f Do not attempt to modify or disassemble the remote control.
f Please observe the following contents that are described on the back of the remote control unit (see the picture below).
g Do not use a new battery together with an old battery.
g Do not use unspecified batteries.
g Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the "Read this first!".
Note
f The remote control can be used within a distance of about 30 m (98'5") if pointed directly at the remote control signal receiver. The remote
control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.
f You can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to the loss of light
caused by the properties of the screen.
f When the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become inoperative. Set
the projector as far from the luminous source as possible.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.

Projector body

r Front
1 2 3 4 5
6
10 7
r Rear

: Projection direction
1 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
2 Light source indicator <LIGHT>
Indicates the status of the light source.
3 Temperature indicator <TEMP>
Indicates the internal temperature status.
4 Focus Lever
Adjusts the focus.
5 Zoom Lever
Adjusts the zoom.
6 Remote control signal receiver
7 Projection Lens
8 Air intake port
9 Front adjustable foot
Adjusts the projection angle.
26 - ENGLISH
Chapter 1 Preparation - About your projector
1.Do not use old battery with new one.
2.Do not use batteries other than the
type specified.
3.Be sure the batteries are inserted properly.
Caution label at the back of the remote control
8
10
9
12
13 14
Made in China
r Side
15
10 Rear adjustable feet
Adjusts the projection angle.
11 Air exhaust port
12 Security slot
This security slot is compatible with the Kensington security
cables.
13 Connecting terminals (x page 28)
14 <AC IN> terminal
Connects the supplied power cord.
15 Speaker
16 Air filter cover
The air filter unit is inside.
11
16 8