Drive Oil Diverter Manifold Components (Welder Option) - Genie S-80 Service Manual

February 2012
8-11

Drive Oil Diverter Manifold Components (welder option)

The oil diverter manifold is mounted to the hydraulic generator located in the engine compartment.
Index
No. Description
1 Directional Valve ............................ CU ........... Diverter valve ............................... 80-90 ft-lbs / 108-122 Nm
2 Orifice disc, 0.031 inch / 0.8 mm .... CV ........... Delays shift to drive
3 Solenoid valve ............................... CW .......... Pilot valve to diverter ....................... 35-40 ft-lbs / 47-54 Nm
4 Relief valve .................................... CX ........... Charge pressure circuit ................... 35-40 ft-lbs / 47-54 Nm
5 Pressure switch .............................. CZ ........... Power to relay .............................................. 16 ft-lbs / 22 Nm
6 Connector ........................................ --- ............ For pressure switch ..................................... 11 ft-lbs / 15 Nm
7 Check valve .................................... CY ........... Prevents oil to generator ................. 35-40 ft-lbs / 47-54 Nm
CY
7
6
CZ
5
Part No. 122985
Schematic
Item Function
S-80 • S-85 • S-80X
Section 4 • Repair Procedures
MANIFOLDS
Torque
CU
1
CV
2
CW
3
CX
4
4 - 57