Perform Function Tests; Test The Oscillate Axle - Genie S-80 Service Manual

February 2012
A-4

Perform Function Tests

Genie specifications require that this procedure be
performed daily.
Completing the function tests is essential to safe
machine operation. Function tests are designed to
discover any malfunctions before the machine is
put into service. A malfunctioning machine must
never be used. If malfunctions are discovered, the
machine must be tagged and removed from
service.
Complete information to perform this procedure is
available in the appropriate operator's manual.
Refer to the Operator's Manual on your machine.
Part No. 122985
Section 3 • Scheduled Maintenance Procedures
A-5

Test the Oscillate Axle

Genie specifications require that this procedure be
performed daily.
Proper axle oscillation is essential to safe machine
operation. If the axle oscillation system is not
operating correctly, the stability of the machine is
compromised and it may tip over.
1 Start the engine from the platform controls.
2 Drive the right steer tire up onto a
6 inch / 15 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground and the chassis
should remain level at all times.
3 Drive the left steer tire up onto a 6 inch / 15 cm
block or curb.
Result: The three remaining tires should stay in
firm contact with the ground and the chassis
should remain level at all times.
4 Drive both steer tires up onto a
6 inch / 15 cm block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Note: If the chassis does not remain level during
the test, refer to Repair Procedure 14-2, How to Set
Up the Directional Valve Linkage.
S-80 • S-85 • S-80X
CHECKLIST A PROCEDURES
Tip-over hazard. Failure to perform
this procedure on a firm, level
surface will compromise the
stability of the machine and could
result in the machine tipping over.
3 - 9