Platform Components; Platform - Genie S-80 Service Manual

February 2012
2-1

Platform

How to Remove the Platform
1 Remove the cable clamp from the top of the
platform mounting weldment.
2 Remove the mounting fasteners from the power
to platform outlet box bracket. Lay the outlet
box and bracket assembly off to the side. Do
not disconnect the wiring.
3 Remove the foot switch mounting fasteners.
4 Remove the cover plate from the bottom of the
foot switch to access the foot switch wire
terminals.
5 Tag and disconnect the foot switch wiring from
the foot switch. Remove the cable from the
back of the platform.
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
6 Remove the platform control box mounting
fasteners. Lower the control box and set it
aside.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
Note: If your machine is equipped with an airline to
platform option, the airline must be disconnected
from the platform before removal.
Part No. 122985

Platform Components

7 Support and secure the platform to an
appropriate lifting device.
8 Remove the platform mounting fasteners and
remove the platform from the machine.
S-80 • S-85 • S-80X
Section 4 • Repair Procedures
Crushing hazard. The platform
could become unstable and fall
when it is removed from the
machine if not properly supported.
4 - 9