Genie S-80 Service Manual page 46

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
4 Remove the drive hub mounting bolts. Carefully
remove the turntable rotate drive hub assembly
from the machine.
Crushing hazard. The turntable
rotate drive hub assembly could
become unbalanced and fall if not
properly supported by the lifting
device.
5 Remove the plug the drive hub. Drain the oil
from the hub into a suitable container.
Single fill port rotator
a motor
b fill port
c drive hub mounting bolts
d drive hub
3 - 16
a
b
c
d
S-80 • S-85 • S-80X
Dual fill port rotator
a motor
b drive hub
c drive hub mounting bolts
d fill ports
6 Install the drive hub assembly onto the machine.
Torque the drive hub mounting bolts to
specification. Refer to Section 2, Specifications.
7 Fill the drive hub with oil. Refer to Section 2,
Specifications. Apply pipe thread sealant to the
plug. Install the plug.
8 Adjust turntable rotation gear backlash. Refer to
Repair Procedure 10-1, How to Adjust the
Turntable Rotation Gear Backlash.
February 2012
a
b
c
d
Part No. 122985