6-16
Motorola Solutions AP-7131N-FGR Access Point Product Reference Guide
6.6.1 Configuring LAN to WAN Access
The access point LAN can be configured to communicate with the WAN side of the access point. Use
the
Subnet Access
interface. This access level will function as an ACL in a router to allow/deny certain IP addresses or
subnets to access certain interfaces (or subnets belonging to those interfaces) by creating access
policies.
To configure access point subnet access:
1. Select
Network Configuration
menu tree.
2. Refer to the
possible colors indicate the current access level, as defined, for each subnet association.
Color
Green
Yellow
Red
screen to control access from the LAN1 (or LAN2) interfaces to the WAN
->
Overview
field to view rectangles representing subnet associations. The three
Access Type
Full Access
Limited Access
No Access
Firewall
->
Subnet Access
Description
No protocol exceptions (rules) are specified. All traffic may
pass between these two areas.
One or more protocol rules are specified. Specific protocols
are either enabled or disabled between these two areas.
Click the table cell of interest and look at the exceptions
area in the lower half of the screen to determine the
protocols that are either allowed or denied.
All protocols are denied, without exception. No traffic will
pass between these two areas.
from the access point