Motorola P-7131N-FGR Product Reference Manual page 204

5-58 Motorola Solutions AP-7131N-FGR Access Point Product Reference Guide
ERP Protection
HT Protection
3. Configure the
diversity setting, radio transmit power level and data rate.
802.11 b/g/n mode
Extended Rate PHY (ERP) allows 802.11g MUs to interoperate with
802.11b only MUs. ERP Protection is managed automatically by the
access point and informs users when 802.11b MUs are present
within the access point's coverage area. The presence of 802.11b
MUs within the 802.11g coverage area negatively impacts network
performance, so this feature should looked to as an indicator of
why network performance has been degraded.
Displays the HT Protection state, and whether a non HT protected
MU is currently associated with the access point.
Channel, Power and Rate Settings
For radio1, specify
to define whether the 802.11b/g/n radio transmits in the 2.4 Ghz
band exclusively for 802.11b (legacy) clients or transmits in the 2.4
Ghz band for 802.11g/n clients. Selecting b and g enables the
access point to transmit to both b and g clients if legacy clients
(802.11b) partially comprise the network. Select accordingly based
on the MU requirements of the network.
The rates for the access point's 2.4 GHz radio are as follows:
B, G and N - Allows only basic rates (default setting).
B and G - Allows 11b basic rates. Does not allow MCS rates.
G and N - Requires basic rates (either 6, 12, 24 or 1, 2, 5.5, 11, 6,
12, 24).
G Only - Requires one 11g basic rate. Does not allow MCS rates.
B Only - Allows for 11b rates only. Does not allow G or N rates.
N Only - Requires basic MCS rates.
Note: If the mode is B and G, the Channel Width option is not
available, and a Secondary Channel cannot be defined.
For the 5 GHz radio, specify
whether the 802.11a/n radio transmits in the 5 Ghz band
exclusively for 802.11a clients, 802.11n clients or transmits in the
5 Ghz band for both 802.11a/n clients.
A Only - Allows 11a rates.
N Only - Requires basic MCS rates.
A and N - Allows only 11a basic rates (default setting).
field to assign a channel, antenna
B, G and N, B and G, G
A and N, A Only
Only, B only or N Only
or N Only to define