Configuring Lan To Wan Access - Motorola AP-7131N-FGR Product Reference Manual

6. Click Undo Changes
settings displayed on the Firewall screen to the last saved configuration.
7. Click Logout
logout before the applet is closed.

6.6.1 Configuring LAN to WAN Access

The access point LAN can be configured to communicate with the WAN side of the access point. Use
the Subnet Access screen to control access from the LAN1 (or LAN2) interfaces to the WAN
interface. This access level will function as an ACL in a router to allow/deny certain IP addresses or
subnets to access certain interfaces (or subnets belonging to those interfaces) by creating access
policies.
To configure access point subnet access:
1. Select Network Configuration
menu tree.
2. Refer to the Overview
possible colors indicate the current access level, as defined, for each subnet association.
Color
Green
Yellow
Red
(if necessary) to undo any changes made. Undo Changes reverts the
to securely exit the Access Point applet. A prompt displays confirming the
->
field to view rectangles representing subnet associations. The three
Access Type
Full Access No protocol exceptions (rules) are specified. All traffic may
pass between these two areas.
Limited Access One or more protocol rules are specified. Specific protocols
are either enabled or disabled between these two areas.
Click the table cell of interest and look at the exceptions
area in the lower half of the screen to determine the
protocols that are either allowed or denied.
No Access All protocols are denied, without exception. No traffic will
pass between these two areas.
Firewall -> Subnet Access
Description
Configuring Access Point Security
from the access point
6-17