Table of Contents
Advertisement
Refer to
RF Band of Operation
radio. After the settings are applied within this Radio Configuration screen, the
Status
and
MUs connected
network, these values update in real-time.
NOTE This section describes mesh networking (setting the radio's base and
client bridge configuration) at a high level. For a detailed overview on the
theory of mesh networking, see
For detailed information on the implications of setting the mesh
configuration, see
review mesh network deployment scenarios, see
Deployment - Quick Setup on page
2. Set the
Maximum MUs
The maximum number of MUs that can associate to an AP-7131N-FGR is 127. Therefore, the
possible number of MUs that can associate to each radio must be negotiated between 0 and
127.
NOTE The AP does not support MU radio associations if its Maximum MUs value
is set to 0. Alternatively, if you set the value to 127 for one radio, you risk
shutting out MU associations for the other radio, as the AP does not
validate the logic of a user's MU association distribution.
3. Select the
Base Bridge
from other access points in client bridge mode. The base bridge is the acceptor of mesh
network data from those client bridges within the mesh network and never the initiator.
4. If the Base Bridge checkbox has been selected, use the
to define the client bridge load on a particular base bridge.
The maximum number of client bridge connections per radio is 12, with 24 representing the
maximum for dual-radio models.
CAUTION An access point is Base Bridge mode logs out whenever a Client
Once the settings within the Radio Configuration screen are applied (for an initial
deployment), the current number of client bridge connections for this specific radio displays
parameter to ensure you are enabling the correct
values update. If this is an existing radio within a mesh
Configuring Mesh Networking Support on page
between 0 - 127.
checkbox to allow the radio to accept client bridge connections
Bridge associates to the Base Bridge over the LAN connection. This
problem is not experienced over the access point's WAN connection. If
this situation is experienced, log-in to the access point again.
Mesh Networking Overview on page
Mesh Network
9-20.
Max# Client Bridges
Network Management
5-53
Radio
9-1.
9-7. To
parameter
Advertisement
Table of Contents
