Table of Contents
Advertisement
j. Specify the
starts, the ISP authenticates the password.
For additional access point WAN port configuration options, see
on page
5-16.
6. Select the
LAN#1
a. Select the
point's LAN connection. The LAN connection is enabled by default.
b. Use the
This Interface
is defined over the LAN connection. Select
uses DHCP. DHCP is a protocol that includes mechanisms for IP address allocation and
delivery of host-specific configuration parameters from a DHCP server to a host. Some
of these parameters are IP address, network mask, and gateway. Select
to use the access point as a DHCP server over the LAN connection. Select the
client
option to enable a diskless system to discover its own IP address.
.
NOTE Motorola Solutions recommends that the WAN and LAN ports should not
c. Enter the network-assigned
NOTE DNS names are not supported as a valid IP address for the access point.
d. The
Subnet Mask
the network domain, the next set specifies the subset of hosts within a larger network.
These values help divide a network into subnetworks and simplify routing and data
transmission.
e. If using the static or DHCP Server option, enter a
numerical IP address of a router the access point uses on the Ethernet as its default
gateway.
f. If using the static or DHCP Server option, enter the
address.
g. If using the DHCP Server option, use the
specify a range of IP address reserved for mapping clients to IP addresses. If a manually
(static) mapped IP address is within the IP address range specified, that IP address could
Password
entered when connecting to the ISP. When the Internet session
tab to set a minimum set of parameters to use the LAN#1 interface.
Enable LAN Interface
drop-down menu to specify how network address information
both be configured as DHCP clients.
IP Address
The user is required to enter a numerical IP address.
defines the size of the subnet. The first two sets of numbers specify
checkbox to forward data traffic over the access
DHCP Client
if the larger corporate network
of the access point.
Default Gateway
Primary DNS Server
Address Assignment Range
Getting Started
Configuring WAN Settings
DHCP Server
Bootp
to define the
numerical IP
parameter to
3-13
Advertisement
Table of Contents
