Table of Contents
Advertisement
B-4
Motorola Solutions AP-7131N-FGR Access Point Product Reference Guide
11. For the ESP Type, select
encryption algorithm and
12. Select the
13. Select
Pre Shared Key (PSK)
14. Enter a Passphrase. Passphrases must match on both VPN devices.
NOTE Ensure the IKE authentication Passphrase is the same as the Pre-shared
15. Select
AES 128-bit
16. Select
Group14
screen.
17. Click
Apply
18. Check the
automatically refreshes to get the current status of the VPN tunnel. Once the tunnel is
active, the IKE_STATE changes from NOT_CONNECTED to SA_MATURE.
19. On access point #2/ Device #2, repeat the same procedure. However, replace access point
#2 information with access point #1 information.
20. Once both tunnels are established, ping each side of the tunnel to ensure connectivity.
ESP with Authentication
SHA1
IKE Settings
button.
from the IKE Authentication Mode drop-down menu.
key on the Cisco PIX device.
as the IKE Encryption Algorithm.
as the Diffie -Hellman Group. Click OK. This will take you back to the VPN
to make the changes
VPN Status
screen. Notice the status displays "NOT_ACTIVE". This screen
and use
as the ESP authentication algorithm. Click OK.
AES 128-bit
as the ESP
Advertisement
Table of Contents
