Table of Contents
Advertisement
8-2
Motorola Solutions AP-7131N-FGR Access Point Product Reference Guide
8.1 Connecting to the CLI
8.1.1 Accessing the CLI through the Serial Port
To connect to the access point CLI through the serial port:
1. Connect one end of a null modem serial cable to the access point's serial connector.
2. Attach the other end of the null modem serial cable to the serial port of a PC running HyperTerminal or a similar emulation
program.
3. Set the HyperTerminal program to use 19200 baud, 8 data bits, 1 stop bit, no parity, no flow control, and auto-detect for terminal
emulation.
4. Press <ESC> or <Enter> to enter into the CLI.
5. Enter the default username of
point, you are unable to access any of the access point's commands until the country code is set. A new password will also need
to be created.
8.1.2 Accessing the CLI via SSH
To connect to the access point CLI through a SSH connection:
1. If this is your first time connecting to your access point, keep in mind the access point uses a static IP WAN address (10.1.1.1).
Additionally, the access point's LAN port default static IP address is 192.168.0.1/24.
2. Enter the default username of
point, you are unable to access any of the access point's commands until the country code is set. A new password will also need
to be created.
login as: admin
AP-713x Access Point 4.0.4.0-031GRN
Copyright (c) 2006-2011 Motorola Solutions, Inc.
This Device Is Running In Common Criteria Mode
Attention:
This is a protected and private wireless system. No un-authorized access is allowed.
You must have proper rights to access and manage this system from authorized personnel.
Using keyboard-interactive authentication.
Password:
admin>
admin
and the default password of motorola. If this is your first time logging into the access
admin
and the default password of motorola. If this is your first time logging into the access
Advertisement
Table of Contents
