Tektronix PHASER 560 Service Manual page 75

Downloaded from www.Manualslib.com
Configuring the printer
1. Set the printer's IP address as described in the earlier topic "Setting the
printer's IP address using the front panel" on page 2-37. Alternately,
you can create a RARP or BOOTP configuration file to automatically
configure the printer's IP address (although it will not be stored in the
printer's NVRAM).
2.
Optionally, configure the printer's TCP/IP parameters. This can be
done using PhaserLink or by downloading PostScript snippets created
from a shell script:
lpr, the host access list (if the customer site uses lpr and filtering).
AppSocket, the printer language(s) supported by the printer (if the
customer site uses AppSocket and filtering).
Syslog, collect printer information for the network administrator.
SNMP, allow the administrator to query and control the printer's status
remotely.
HTTP. As you set the printer's IP address, also set the gateway address
as described in the earlier topic "Setting the printer's IP address using
the front panel" on page 2-37.
FTP. An ftp session is opened with the ftp command, followed by the
printer's IP address. The put command is used to send the file
sample-file.ps to the printer. The bye command terminates the
connection.
ftp 134.67.66.11
put sample-file.ps
bye
Telnet. If the printer is to be used with standard TELNET clients, the
DataPortNumber parameter must be set to 23 decimal (23 is the
default).
manuals search engine
Installing the Printer and Drivers
Service Manual
2
2-43