Printer Controls And Indicators; Loading Media - Tektronix PHASER 560 Service Manual

4
Key Operator Training

Printer controls and indicators

Loading media

4-2 Phaser 560 Color Printer
Downloaded from www.Manualslib.com
Review the controls and indicators with the key operator.
Explain the front panel and how to "navigate" its menu using the
front panel buttons; refer to the user manual.
Demonstrate how to use the front panel menu to print a menu map of
the front panel.
Show and explain the customer how to observe the flashing health
LED through the grill behind the manual feed tray.
Show and explain to the customer the RX (receive) and TX (transmit)
LEDs on the rear panel of the network card (if installed).
Paper/transparency: Demonstrate how to load paper or transparency film into
the appropriate media tray.
Emphasize to the customer not to touch the printing surface of the
transparency media; handle it by the edges only. Fingerprints can
affect print quality.
Explain that the customer should not bend the media (especially
transparency film) too sharply. Otherwise, print quality may be
affected.
Demonstrate fanning the media (especially transparency film) prior to
installing it in the paper tray.
Transparency film should not be fed from the lower tray of the Lower
Tray Assembly. Show where this is explained in the user manual.
Before loading paper into the tray, there are a few factors to consider:
Paper grain: short or long
Grade, weight and thickness:
Bond: 61 to 90 g/m
Show a customer how this information is labeled on a package of paper and
where in the user manual paper specifications are found.
Explain to customers that many 105 g/m
problems. However, jamming is more likely if the prints are output in
face-down mode. Face-up output should be used with heavy stock paper for
the best reliability.
manuals search engine
2
(16 to 24 lbs.)
2
(28 lb) papers will tray feed without