Table 9-2 Normal Operation Error Codes - Tektronix PHASER 560 Service Manual

9
Checks and Adjustments
9-8 Phaser 560 Color Printer
Downloaded from www.Manualslib.com
Normal operation. A two digit error code with the suffix "e" indicates the failure
occurred after the power-up self tests have completed and the PostScript
software had started. The cause of such an error is one of the printer
sub-assemblies such as the fuser or imaging unit. These are discussed in more
detail in the Chapter 6 topic "Error messages" on page 6-17.
The health LED, located on the image processor board, flashing in a regular, one
flash-per-second rate means no errors were detected and the image processor's
CPU is running.

Table 9-2 Normal operation error codes

Process Errors
01 Black Cartridge Movement Error
02 Cyan Cartridge Movement Error
03 Magenta Cartridge Movement Error
04 Yellow Cartridge Movement Error
05 Toner Cartridge/Fuser Fan Error
Laser Scanner Errors
10 Scanner Motor Unlocked
11 Laser Power-down Error
12 LSync Over
13 LSync Short
20 Charger Error
21 Asynchronous OPC
22 OPC Positioning Error
30 Intermediate Transfer Positioning Error
32 Cleaning Blade Movement Error
33 Paper Transfer Roller Movement Error
Fuser Errors
40 Fuser Low Temperature
41 Fuser High Temperature
42 Fuser Thermistor Open Error
43 Fuser Rising Temperature
manuals search engine
Fan Errors
50 Power Supply Fan Error
51 Filter Fan Error.
Motor Errors
60 Multi-Purpose Pickup Roller
Movement Error
61 Sleeve Motor Unlocked
62 Transportation Motor Unlocked
63 Main Motor Unlocked
Engine Control Circuit Errors
70 Program ROM Check Sum Error
71 SRAM Check Error
72 EEPROM Check Error (ECU)
73 EEPROM Check Error (CIK unit)
74 EEPROM Check Error (Fuser unit)
Engine Communication Errors
80 VSync Timeout Error
81 No Power Error
82 Serial Reply Timeout Error
83 Illegal Command Error
84 Parity Error