Figure 8-3 Removing The Emi Shields - Tektronix PHASER 560 Service Manual

8
FRU Disassembly/Assembly
EMI shields
EMI shield
Interconnect
wiring shield

Figure 8-3 Removing the EMI shields

8-6 Phaser 560 Color Printer
Downloaded from www.Manualslib.com
Use a magnetic screwdriver when removing the many screws securing EMI
shields in place to avoid losing the screws in the printer. Note the placement of
the shields and the routing of all cables prior to removing them.
1.
Remove the upper rear cover and top cover as detailed in the earlier
procedures "The printer cabinet" on page 8-2.
2. Remove the interconnect wiring shield by removing the six screws
securing it in place. Lift and remove the shield.
3.
Unplug the engine-to-image processor cable from the engine control
board.
4. Remove the 13 screws securing the large EMI shield in place.
Carefully tilt up the bottom of the shield and remove it. Ensure that
no wiring harness hangs up on the shield.
Reverse these steps to install the shields. Ensure that no cables are pinched by
the shields as you install them.
manuals search engine
9697-10