Figure 8-16 Removing The High-Voltage Board - Tektronix PHASER 560 Service Manual

Figure 8-16 Removing the high-voltage board

Downloaded from www.Manualslib.com
Card cage
Caution When installing the wiring harness retainer, be careful not to press
the wiring harness against the tip of a near by screw which will
short the harness. The bent edge of the restraint faces the front of
the printer.
Reverse these steps to install the high voltage board. Be sure to correctly place
the card cage on its alignment pin.
Note The colored orientation stripe of the front panel wiring harness must
be oriented up to properly connect with the connector inside the card
cage.
manuals search engine
Cut hazard
here
FRU Disassembly/Assembly
Wiring
harnesses
Be careful not
to short harness
here to nearby
screw tip
High-voltage
board
Service Manual
8
9697-18
8-25