Figure 8-14 Removing The Temperature/Humidity Sensor Board - Tektronix PHASER 560 Service Manual

8
FRU Disassembly/Assembly
Temperature/humidity sensor board
8-22 Phaser 560 Color Printer
Downloaded from www.Manualslib.com
1.
Remove the upper and lower rear covers and the left side cover as
explained in the earlier procedure, "The printer cabinet" on page 8-2.
2. At the lower rear cover, slide out the white plastic housing containing
the temperature/humidity sensor board
3. Unclip the sensor board from its housing. Disconnect the sensor's
wiring harness. Do not touch the surface of the humidity sensor.
Lower rear
cover

Figure 8-14 Removing the temperature/humidity sensor board

Reverse these step to install the temperature/humidity sensor board.
manuals search engine
Housing
Temperature/humidity
sensor board
9697-46