Tektronix PHASER 560 Service Manual page 49

Table 2-1 Configuration page settings for the Phaser 560 (cont'd.)
Parameter
Boot Delay
Check parity
Disk Address
Printer address
CopyStation
PCL
PhaserShare
Ethernet
Address
Firmware
version
EtherTalk Port
interpreter
EtherTalk
Printer type
EtherTalk Zone
EtherTalk
Network
EtherTalk Node
TokenTalk
interpreter
Token Ring
Address
Speed
Bridging
All Routes
Broadcast
Downloaded from www.Manualslib.com
Description
Number of seconds the printer waits
before booting up the attached hard
drive.
If true, data parity should be checked.
SCSI address of disk for the SCSI
communication channel.
SCSI address of printer when it is the
initiator.
Indicates if a CopyStation is attached to
the printer
Indicates if PCL 5 has been authorized.
Indicates the type of Phaser Share
network card installed
A unique number for each
Ethernet-capable printer.
Firmware version of the installed
Ethernet card
Indicates the type of interpreter in use at
the port.
Indicates the type of printer installed at
the port.
Name assigned by network administrator
for the zone the printer is assigned to.
The EtherTalk protocol address
assigned at boot time for routing.
Indicates the EtherTalk address of a
printer on the network.
Indicates the type of interpreter in use at
the port.
A unique number for each printer. based
on the printer's ID.
Data transmission speed the network
card is set to. Set by a jumper on the
card. (Jumper not installed equals
16 Mbps, jumper installed equals
4 Mbps).
Token Ring source routing.
The printer sends response packets
back to the host indicating all possible
routes to the printer.
manuals search engine
Installing the Printer and Drivers
Saved Default Limits or alternate choices
in
NVRAM
yes 0 Any positive integer
False True
no 6 0 to 7
no 7 0 to 7
no
yes Authorized Not authorized
no none LocalTalk/Serial, Ethernet,
Token Ring
yes Hardware-
dependent.
Legal values
have the form
xx:xx:xx:xx:xx:xx
no
yes PostScript Level 2 Not installed, Disabled,
<interpreter>
LaserWriter Any string, 32 character or
less
yes * Any string, 32 characters or
less
yes 0 Integer 1 through 65534
yes 0 Integer 1 through 253
yes PostScript Not installed, Disabled,
Level 2 <interpreter>
yes None Any valid token ring address
yes 16 Mbps 4 Mbps
yes Adaptive (printer Transparent (no source
determines route routing), SourceRoute (use
based on data) source routing)
yes False True
2
2-17
Service Manual