0650" "Fi" Check Lamp Circuit Malfunction - HYOSUNG 2010 ST7 Service Manual

"0650" "FI" CHECK LAMP CIRCUIT MALFUNCTION

LCD (DISPLAY) INDICATION
0650
DETECTED CONDITION
☞ ☞ Refer to page 4-26
▣ ▣ INSPECTION
1) Remove the frame cover.
2) Turn the ignition switch "OFF" position.
3) Disconnect the combination meter lead wires.
4) Connect the battery
the combination meter and the battery
to the LY wire of the combination meter directly.
Is the "FI" check lamp come on?
● LY or OB wire open or shorted to
ground, or poor
connection of ECU coupler.
● If wire and connection are OK,
YES
intermittent trouble or faulty ECU.
● Recheck each terminal and wire
harness for open circuit and poor
connection.
Replace the combination meter with a
NO
new one.
[ 0
terminal to the O wire of
terminal
G3 or
B15
"FI" CHECK LAMP INDICATION
6 5 0
POSSIBLE CAUSE
● "FI" check lamp circuit open and short.
● "FI" check lamp malfunction.
● ECU malfunction.
Gray
ECU Coupler
EI SYSTEM DIAGNOSIS 4-48
0 6
Black
Black
]